V-862
VICTORY SLASH PIPES FOR 2005 – PRESENT HAMMER & JACKPOT MODELS
V-872
VICTORY SLASH PIPES FOR 2006 – PRESENT VEGAS & KINGPIN MODELS
Thank you for purchasing this RPW USA product. We believe that our products are the very best available and are engineered to provide a lifetime of use. These RPW Slash pipes can be installed on Victory Hammer & Jackpot models from 2003 to present and the Victory Vegas & Kingpin models from 2006 to present. Basic hand tools and a service manual applicable to your model of motorcycle are all that is necessary to complete the installation.
BILL OF MATERIALS
Part # Quantity Description
N/A 1 Front pipe, chrome
N/A 1 Rear pipe, chrome
N/A 1 Front heat shield, chrome
N/A 1 Rear heat shield, chrome
N/A 1 Mounting bracket
N/A 2 Baffles
N/A 4 Exhaust clamp half
N/A 5 Hose clamp, stainless steel
N/A 2 1/4” – 20 hex nut, stainless steel
N/A 2 1/4” washer, external star
N/A 2 5/16” – 18 x 1” button head cap screw, stainless steel
N/A 2 1/4” - 20 x ½” button head cap screw, stainless steel
N/A 2 5/16” lock washer
N/A 4 5/16” flat washer
N/A 2 5/16” – 18 hex nut, stainless
N/A 1 3/8” flat washer
N/A 1 Set of instructions
N/A 1 Warning Label
MAINTENANCE TIP: To keep your new Slash Ness pipes looking their best, we recommend applying a high-quality chrome polish to them every time you detail your motorcycle.
Please Note: Pipes are not warranted against bluing and UNDER NO CIRCUMSTANCE will pipes be warranted after they have been run on an engine. See TUNING TIP in Step 9.
STEP 1: Begin by removing the existing pipes from the motorcycle, and then inspect the exhaust gaskets. If they are worn or deteriorated, fit the engine with a new set.
STEP 2: Installation of Slash pipes requires the lower frame rail to be cut off as shown. Deburr the frame rail with a file or burr knife to leave a smooth edge and cover any bare metal with touch-up paint to prevent rust.
STEP 4: To install the heat shields, slip the supplied hose clamps through the hoops welded onto the backside of each shield as shown. Install the heat shields onto the pipes and tighten all hose clamps evenly, aligning the shields with the exhaust pipes for proper fit.
STEP 6: The front pipe must be carefully “snaked” in past the engine and foot controls as shown. Work the pipe in slowly and carefully to avoid scratching the chrome or finish.
STEP 7: Split exhaust clamps are included for both pipes. They are oriented as shown in the inset photo and can be installed on the engine one half at a time. As shown in the main photo this greatly helps the installation of the front pipe. Repeat this process for the rear pipe installation and snug all exhaust flange nuts, but do not tighten them completely.
STEP 9: Prior to starting the engine, wipe the pipes down with lacquer thinner or acetone on a clean rag. Start your engine and check for exhaust leaks. You are now ready to enjoy your RPW USA Slash exhaust pipes. Installation of this exhaust will require the use of the Victory Stage 1 Performance CPU re-flash. See your Victory dealer for details.
TUNING TIP – To help prevent bluing, the engine should be properly tuned before running it with the new exhaust. We recommend for an Adjustable Fuel Tuner or Victory’s download #4011322 and for 08 and up Victory’s download #4012185.
Directions: